Removing A Qfx3600 Or Qfx3600-I Device From A Rack Or Cabinet - Juniper QFX5110 Series Hardware Documentation

4. Place the removed screws and mounting blades in a labeled bag. You will need them when you reinstall
the chassis.
5. Transport the QFX5100 device to your desired new location.
RELATED DOCUMENTATION
Mount a QFX5100 Device in a Rack or Cabinet | 279

Removing a QFX3600 or QFX3600-I Device from a Rack or Cabinet

If you need to relocate an installed QFX3600 or QFX3600-I device, use the procedure described in this
topic. (The remainder of this topic uses "rack" to mean "rack or cabinet.")
NOTE: When you remove multiple devices from a rack, remove the device in the top of the rack
first and proceed to remove the rest of the devices from top to bottom.
Before removing a QFX3600 or QFX3600-I device from a rack:
Ensure that the rack is stable and secured to the building.
Ensure that there is enough space to place the removed QFX3600 or QFX3600-I device in its new
location and along the path to the new location.
Read "General Safety Guidelines and Warnings" on page
Ensure that the QFX3600 or QFX3600-I device has been safely powered off (see
QFX3600 Device" on page
Ensure that you have disconnected any cables or wires attached to the QFX3600 or QFX3600-I device
ports.
Ensure that you have the following parts and tools available:
A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your rack mounting screws,
for mounting the QFX3600 or QFX3600-I device on the rack.
To remove a QFX3600 or QFX3600-I device from a rack or cabinet:
412) and that you have unplugged (disconnected) the power cords.
203.
"Powering Off a
419