Front Panel Of A Qfx3600 Device - Juniper QFX5110 Series Hardware Documentation

and in other releases, the port is available. See the topics on channelizing interfaces or configuring the
port type for your specific software release.
The rear panel of the QFX3600 chassis has two redundant power supplies and three redundant fan trays
that are field-replaceable and hot-swappable. See Rear Panel of QFX3600 and QFX3600-I Devices.
RELATED DOCUMENTATION
Field-Replaceable Units for QFX3600 and QFX3600-I Devices
Site Preparation Checklist for a QFX3600 or QFX3600-I Device | 93
Installing and Removing QFX3600 or QFX3600-I Device Hardware Components | 444

Front Panel of a QFX3600 Device

The front panel of the QFX3600 device consists of the following components:
LCD panel—The LCD panel displays the device hostname and the number of active alarms.
TIP: Alternatively, you can use the show chassis lcd CLI command to view what is currently
displayed on the LCD panel.
Chassis status LEDs
USB port
Console (CON) port
Management ports—The QFX3600 device has four management ports. The ports labeled C0 and C1 are
1000BASE-T RJ-45 ports, and the ports labeled C0S and C1S are 1-Gbps SFP ports.
If you are using the QFX3600 device as a Node device in a QFabric system, these ports are used to
connect the QFX3600 device to the QFabric system control plane and management network. See
Determining Transceiver Support for QFabric Systems for information about the supported transceivers
and required cables.
If you are using the QFX3600 device as a standalone switch, these ports are used to connect the
QFX3600 device to a management network. See
Connections for the QFX Series" on page 146
"Cable Specifications for Console and Management
for information about the required cables.
48