Install A Transceiver - Juniper QFX5110 Series Hardware Documentation

Figure 178: Installing a QSFP28 Transceiver in a QFX10002
RELATED DOCUMENTATION
Removing a Transceiver from a QFX Series Device | 476
Connecting a Fiber-Optic Cable to a QFX Series Device | 488

Install a Transceiver

The transceivers for Juniper Networks devices are hot-removable and hot-insertable field-replaceable
units (FRUs): You can remove and replace them without powering off the device or disrupting the device
functions.
NOTE: After you insert a transceiver or after you change the media-type configuration, wait for
6 seconds for the interface to display operational commands.
NOTE: We recommend that you use only optical transceivers and optical connectors purchased
from Juniper Networks with your Juniper Networks device.
CAUTION:
third-party optic or cable, the Juniper Networks Technical Assistance Center (JTAC)
can help you diagnose the source of the problem. Your JTAC engineer might recommend
that you check the third-party optic or cable and potentially replace it with an equivalent
Juniper Networks optic or cable that is qualified for the device.
If you face a problem running a Juniper Networks device that uses a
484