Screen/Button Settings; Ringing Volume - Xerox WorkCentre 5230A System Administration Manual

6 Setups
Job Complete Tone 1 / Job Complete Tone 2
Specifies the volume level of the tone generated when a job is completed successfully.
Select a volume level, and then, under [Targeted Jobs], select the job types to apply
the volume level to.
Fault Tone
Specifies the volume level of the tone generated when a job did not finish properly.
Alert Tone
Specifies the volume level of the tone generated when a job is suspended due to an
error.
Out of Paper Warning Tone
Specifies the volume level of the tone generated when the machine runs out of paper.
Low Toner Alert Tone
Specifies the volume level of the tone generated when it is time to replace the toner
cartridge.
Line Monitor Volume
Specifies the volume level of the tone generated for the line monitor, which allows you
to hear call and response signals when connecting to a destination.

Ringing Volume

Specifies the volume level of the tone generated when a call is received.
Stored Programming Tone
Specifies the volume level of the tone generated each time an operation is performed
during job memory registration. You cannot completely turn off the volume for this tone.
Auto Clear Alert Tone
Specifies the volume level of the tone generated just before the machine performs auto
clear.
Base Tone
Specifies the volume level of the base tone generated when you toggle settings. The
machine emits a base tone when it exits the interrupted mode.

Screen/Button Settings

This feature allows you to customize the initial screen and select the initial language to
be displayed on the touch screen.
1.
Select [Screen/Button Settings]
in the [Features] menu.
2.
Change the required settings.
Use the side tabs to switch
between screens.
3.
Select [Close].
68