High Capacity Tandem Tray (Trays 3 & 4) - Xerox WorkCentre 5230A System Administration Manual

2 Paper and Other Media
NOTE: When changing the size or type of stock in the tray, refer to
Settings in the Setups chapter on page 70.
3.
Load the paper neatly and tightly
against the left-hand side of the
tray.
NOTE: Do not load paper above the
maximum fill line.
NOTE: When making single/double
sided copies on perforated paper,
load the paper to feed the opposite
side of the perforated edge first.
Feeding the perforated edge first may cause paper jams.
4.
If the paper guides have been
moved, slide the guides to just
touch the edge of the paper.
NOTE: When loading standard size
paper, set the guides onto the
notches on the tray to match the
paper size. The machine recognizes
8K/16K paper as standard sizes
even though the paper trays have no
notches for these sizes.
5.
Close the paper tray.
NOTE: Paper can be loaded either
short edge feed or long edge feed.
6.
Set the machine to detect the
paper size automatically, or
manually specify the required
size. For more information,
refer to
NOTE: Paper sizes detected by the machine vary depending on the system settings.
For more information, refer to
High Capacity Tandem Tray (Trays 3 & 4)
The High Capacity Tandem Tray (Trays 3 and 4) allows you to load up to 2,000 sheets
of paper.
NOTE: You cannot load custom size paper into the High Capacity Tandem Tray.
1.
Pull out Tray 3 or 4.
The elevator in the tray lowers.
2.
Place the paper stock tightly
against the left rear corner of the
tray.
NOTE: Do not load paper above the
maximum fill line.
18
Paper Size in the Setups chapter on page 70.
Paper Size Settings in the Setups chapter on page 78.
Long edge feed Short edge feed
(LEF) (SEF)
Paper Tray