Other Settings - Xerox WorkCentre 5230A System Administration Manual

Receiving Buffer - EtherTalk
Specifies the input buffer memory capacity for EtherTalk interface within the range of
1024-2048 KB in 32 KB increments using the scroll buttons or the numeric keypad. The
currently available memory will be displayed at the top of the screen with the following
message: "Memory Available: XXX MB."
Receiving Buffer - Port 9100
Specifies the input buffer memory capacity for Port 9100 interface within the range of
64-1024 KB in 32 KB increments using the scroll buttons or the numeric keypad. The
currently available memory will be displayed at the top of the screen with the following
message: "Memory Available: XXX MB."

Other Settings

This feature allows you to specify a printable area and replacement method when
paper runs short.
1.
Select [Other Settings] in the
[Features] menu.
2.
Change the required settings.
Use the scroll buttons to switch
between screens.
3.
Select [Close].
Print Area
Specifies the printable area. Select [Standard] to crop a margin 4.1 mm (0.16 inch) wide
along all four edges of the paper. Select [Extended] to crop a margin of 2 mm (0.08
inch) along the edges.
Substitute Tray
Specifies the substitute tray when the machine cannot detect the paper tray
corresponding to the document size with the auto paper selection.
• Display Message
Specifies a message prompt requesting paper supply be displayed without
switching paper trays.
• Use Larger Size
Specifies switching to the tray loaded with the next larger size of paper and prints
the document in its original size.
• Use Closest Size
Specifies switching to the tray loaded with the paper in the size closest to the
selected paper. Image size may be automatically reduced as required.
NOTE: A job sent from a computer takes priority over a job instigated on the machine.
• Select Tray 5
Specifies switching to Tray 5 (Bypass).
Paper Type Mismatch
Specifies whether to print, display the confirmation screen, or display the paper supply
screen when a paper type mismatch occurs.
System Settings
103