Ethertalk - Xerox WorkCentre 5230A System Administration Manual

However, if the machine is switched off immediately after a print request, the print
data may be stored on the client. In this case, the print request can be reissued when
the machine is switched on, and the print data is printed on the machine.
When printing
• When [Receiving Buffer - LPD] is set to [Spool to Hard Disk] or [Spool to Memory]:
Print data cannot be received if the print data size exceeds the available capacity of
the hard disk or memory allocation.
NOTE: If the print data exceeds the receiving buffer capacity, the client may retransmit
the same print data. In this case, stop the client and make sure that the client does not
transmit the print data.
• When [Receiving Buffer - LPD] is set to [No Spooling]:
Print requests cannot be received from a client if a print request from another client
is being processed.
• When the client IP address or computer name is changed:
When the client IP address or computer name is changed, the machine cannot
perform query processing and cancel processing. Switch the machine off and on
with the receiving buffer empty of print data.
NOTE: Stopping printing or forced deleting of print data in the machine receiving
buffer can be performed using the control panel. For information, refer to
on page 39

EtherTalk

This section explains the troubleshooting procedures and restrictions while using
EtherTalk.
Troubleshooting
The possible causes, confirmation methods, and actions are as follows.
A job was printed on a
different machine than the
assigned machine.
The machine cannot be
accessed from a client.
Problem
If there are multiple machines
on the network with the same
name, the machine names
are changed automatically
depending on the power-on
timing of each machine. Print
jobs intended to be printed on
one machine are sent to
another machine.
The machine name, used by
the client to recognize the
machine, cannot be
registered if the machine is
switched on when not
connected to the network.
Cause
Change the machine names
so that all machine names on
the network are unique.
Switch on the machine after
connecting to the network. If
the machine is switched on
when not connected to the
network, switch off the
machine, connect to the
network, and switch on the
machine again.
Network-related Problems
Job Status
Action
381