Usb Port; Information Checklist - Xerox WorkCentre 5230A System Administration Manual

Test Print
To make sure that the machine has been installed on the network correctly, a test print
should be submitted from each client computer. Perform the following steps.
1.
Open a document on a client computer.
2.
Select the machine as the printer to which the selected document will be sent.
3.
Print the document on the machine and verify that it prints correctly.
4.
Make sure that the driver is installed on every computer that will be sending jobs
to the machine.
5.
Repeat the test for all computers that will be sending jobs to the machine.
The installation process is now complete.
If the test print fails, refer to

USB Port

This section explains how to set up the machine in a USB port environment. The
following information is provided:
Information Checklist – page 267
USB Port Environment – page 268
USB Port Installation – page 268
Installation Procedure – page 268
USB Port Communication Setup – page 268
Computer Setup – page 269
Test Print – page 269

Information Checklist

Before starting the USB port installation procedures, make sure that the following items
are available or have been performed.
USB Cable
Test the machine to make sure that it is fully installed and functioning
correctly.
Install the print driver.
NOTE: The installation procedures will install the machine on the USB port of the host
computer. The procedures are not intended to connect the host computer to other
computers.
If problems are encountered during the installation of the machine, refer to
Solving on page 349
Problem Solving on page 349
Item
.
USB Port
.
By
Customer
Customer
Customer
Problem
267