Xerox WorkCentre 5230A System Administration Manual page 412

15 Problem Solving
Code
024-985
026-700
026-701
026-702
027-400
027-442
027-443
027-444
027-445
027-446
027-447
027-452
027-500
027-501
027-502
027-503
412
An error occurred in Tray 5 (Bypass). Check the document size, orientation and
paper type, and then try executing the same operation again.
A protocol which is not supported on the machine was received from the LDAP
server during the address book query. Try executing the same operation again.
Contact the Xerox Welcome Center if the problem persists.
The number of address book queries exceeded the handling capacity of the
machine. Wait a while, and perform the same operation again. If there was only
one address book query, the problem may be in the machine software. Contact
the Xerox Welcome Center.
The number of transactions from the LDAP server exceeded the handling
capacity of the machine. Wait a while and perform the same operation. Contact
the Xerox Welcome Center if the problem persists.
A communication error occurred. If another error message is displayed, clear
the problem first. If the control panel is being used by a user, wait until the user
operation is completed. If the machine is communicating with a remote device,
wait until the communication is completed.
If the problem persists even after you take the above actions, switch off the
machine, and then switch it on again. If the problem still persists, contact the
Xerox Welcome Center.
The auto stateless IPv6 address 1 of the machine is duplicated on the network.
Change the auto stateless IPv6 address 1 of the machine, or the address of the
other device.
The auto stateless IPv6 address 2 of the machine is duplicated on the network.
Change the auto stateless IPv6 address 2 of the machine, or the address of the
other device.
The auto stateless IPv6 address 3 of the machine is duplicated on the network.
Change the auto stateless IPv6 address 3 of the machine, or the address of the
other device.
The IPv6 address manually set for the machine is invalid. Correct the IPv6
address.
The IPv6 address manually set for the machine is duplicated on the network.
Change the IPv6 address of the machine, or the address of the other device.
The link-local IPv6 address of the machine is duplicated on the network.
Change the link-local address of the machine, or the address of the other
device.
The specified IP address already exists. Change the IP address.
Unable to resolve the name of the SMTP server when reply e-mail was
transmitted. Check using CentreWare Internet Services to see if the SMTP
server is set correctly.
Unable to resolve the name of the POP3 server when using the POP3 protocol.
Check using CentreWare Internet Services to see if the POP3 server is set
correctly.
Unable to log in to the POP3 server when using the POP3 protocol. Check using
CentreWare Internet Services to see if the user name and password used for
the POP3 server are set correctly.
An error occurred in the POP server. Try again. Contact the Xerox Welcome
Center if the problem persists.
Description and Remedy