For more details about each protocol settings, refer to the following section:
FTP:
SMB:
HTTP/HTTPS:
HTTPS (SSL/TLS) Communication Encryption on page 306
NetWare:
4.
A repository (folder) needs to be created on the server to hold scanned
documents.
Data to Set Up Network Scanning
Templates are created via CentreWare
Internet Services or any other Xerox
Network Scanning Solutions.
Repositories are created via CentreWare
Internet Services or any other Xerox
Network Scanning Solutions.
Remote Authentication Server's IP Address Optional
Procedure for Network Scanning Setup
1.
Create templates and repositories via CentreWare Internet Services.
2.
On the control panel, select [Network Scanning].
3.
Select a template from the list. You can change any other value from the control
panel without impacting the template configuration; only the current job will be
affected.
4.
Load a sample document into the document feeder.
5.
Press the <Start> button on the machine. The job is sent to the server using the
protocol as defined within the template.
6.
Log on to the server. Navigate to the repository (folder) that was specified earlier.
Your scanned document is located in that repository.
NOTE: If the authentication feature is enabled for the Network Scanning service, a
separate login screen appears when [Network Scanning] is selected on the All
Services screen. Users can use the service after authenticated.
Computer Setup
For more information about programming templates using CentreWare Internet
Services, refer to
Scan to Home Setup
The Scan to Home feature is supported through the Network Scanning service.
Essentially, it is a template file (.xst) stored locally on the machine, but in a different
directory than the Network Scanning templates or mailbox folders.
Scan to PC Setup (FTP) on page 291
Scan to PC Setup (SMB) on page 292
HTTP on page 198
NetWare on page 188
Install
Requirement
Required
Required
CentreWare Internet Services on page 149
.
.
. For HTTPS, also refer to
.
Comments
Refer to
Job Templates on page 162
Network Scanning on page 209
Refer to
If Remote Authentication is required,
then the Authentication feature needs to
be enabled.
Scan to Home Setup
Configuration of
.
.
.
289
.