Connectivity & Network Setup; Port Settings - Xerox WorkCentre 5230A System Administration Manual

6 Setups
If you predefine frequently used magnifications, the original can be expanded or
reduced, quickly and easily.
1.
Select [Reduce/Enlarge
Presets] in the [Features] menu.
2.
Change the required settings.
Use the scroll buttons to switch
between screens.
3.
Select [Close].
R/E Preset 1 to 7
Specifies the reduce/enlarge ratios assigned to each of the seven buttons. Select from
26 options in the range of 25-400%.
Connectivity & Network Setup
This section describes the features that allow you to change the default settings for the
network configuration. For more information on network setups, refer to
Environment Settings on page 233
NOTE: The options available may vary with the usage environment.
Port Settings – page 90
Protocol Settings – page 92
Machine's E-mail Address/Host Name – page 93
Proxy Server Settings – page 94
Outgoing/Incoming E-mail Settings – page 95
Remote Authentication Server Settings – page 96
Security Settings – page 97
Other Settings – page 100
1.
Select [System Settings], and
then select [Connectivity &
Network Setup] in the [Group]
menu.

Port Settings

This feature allows you to set the print mode, port status, communication mode, and
auto eject time for the communication ports.
1.
Select [Port Settings] in the
[Features] menu.
2.
Change the required settings.
Use the scroll buttons to switch
between screens.
3.
Select [Close].
USB
Specifies whether to enable the USB port and configures the port settings.
90
.
Printer