Tcp/Ip (Lpd Or Port9100) Environments; Tcp/Ip (Lpd Or Port9100) Installation - Xerox WorkCentre 5230A System Administration Manual

8 Printer Environment Settings
If problems are encountered during machine setup, refer to
page 349

TCP/IP (LPD or Port9100) Environments

System configuration
As the machine supports the LPD and Port9100 protocol, you can print directly from a
Windows computer.
When printing from Windows NT4.0/Windows 2000/Windows XP/Windows Server
2003/Windows Vista computers through the LPD port, use the OS standard LPR port.
When printing through Port9100, change the necessary settings on the computers.
The transport protocol for LPD and Port9100 can be TCP/IP.
You will also need to set up the IP address on the machine and the Windows
computers.
NOTE: Windows NT 4.0 does not support printing through Port9100.
Target computers
The following computers support printing through LPD or Port9100.
Connection
LPD port
Port9100
NOTE: The optional PostScript Kit is required when you print from a Macintosh.

TCP/IP (LPD or Port9100) Installation

This section describes how to set up the machine to use the LPD and Port9100
protocols.
Installation Procedure
There are three stages to enable printing on the machine through LPD or Port9100.
Network Communication Setup
Enable the following ports using the touch screen or CentreWare Internet Services.
• Printing through LPD: LPD port
• Printing through Port9100: Port9100 port
Set the IP address using the touch screen.
264
.
Windows NT 4.0
Windows 2000
Windows XP
Windows Server 2003
Windows Vista
Windows 2000
Windows XP
Windows Server 2003
Windows Vista
Problem Solving on
OS
TCP/IP
TCP/IP
Protocol