Pdf Direct Printing; Machine Software Upgrade - Xerox WorkCentre 5230A System Administration Manual

16 Appendix

PDF Direct Printing

Parameter
Print Sets
2 Sided Print
Print Mode
Sort
Layout
Paper Size
Decomposer
Password

Machine Software Upgrade

To upgrade the software, you must first obtain the upgrade software and then install it.
Prepare for the Upgrade
It is important to obtain the correct upgrade file for your machine. Determine the
software version you are currently running, as follows:
1.
Open your web browser and enter http:// and the TCP/IP address of the machine
in the [Address] or [Location] field. Click [Enter].
2.
Click the [Properties] tab.
3.
Click the [General Setup] folder.
440
Item No.
401 1-999 (Default: 1): Specify the number of print sets.
402 0: Off (Default)
1: LEF Binding
2: SEF Binding
Specifies which edge of paper is to be bound for double-sided
printing.
403 0: Standard (Default)
1: Fast
2: High Quality
Selects the print mode.
404 0: Off (Default)
1: On
Sets whether to enable sorting.
405 0: Auto Reduce/Enlarge (Default)
1: Booklet
2: Two-up
3: Four-up
4: 100% (actual size)
Specifies layout options. "0" (Auto Reduce/Enlarge) prints with
magnification to fit the paper size selection. "1" (Booklet) performs
duplex printing. "2" (Two-up) and "3" (Four-up) print two and four
pages on a single sheet of paper, respectively.
406 0: Auto
1: A4 or Letter (Default)
Sets the paper size.
408 0: PDF Bridge (Default)
1: PS
Selects the decomposer.
- Enter a password up to 32 characters.
Value