Xerox WorkCentre 5230A System Administration Manual page 392

15 Problem Solving
Code
013-210
013-211
013-212
013-213
013-220
016-210
016-211
016-212
016-213
016-214
016-215
016-216
016-217
016-218
016-219
016-220
016-221
016-222
016-223
016-224
016-225
016-226
016-227
016-228
016-229
016-230
016-231
016-232
016-240
016-324
016-400
016-401
016-402
016-403
016-404
016-450
016-453
392
The Finisher malfunctioned. Switch off the machine, and then switch it on again.
Contact the Xerox Welcome Center if the problem persists.
An error occurred on the software. Switch off the machine, and then switch it on
again. Contact the Xerox Welcome Center if the problem persists.
The data in the hard disk is being overwritten. Wait until the processing is
completed. To cancel the processing, switch off the machine, and then switch it
on again.
An 802.1x authentication error occurred. The user name or password set in the
machine is not correct, or switch settings on the authentication server have a
problem.
The 802.1x authentication method selected on the machine is not supported by
the authentication server. Change the 802.1x authentication method on the
control panel.
A connection timeout error occurred between the machine and the 802.1x
authentication server. Check the connection between the machine and the
authentication server.
An 802.1x authentication certificate error occurred. The root certificate for the
server certificate of the authentication server is not stored in the machine, or is
invalid. Import a valid root certificate into the machine. Or, set [Server Certificate
Verification] to [Disabled].
An 802.1x authentication error occurred. Try again. Contact the Xerox Welcome
Center if the problem persists.
The SMB host name already exists. Change the host name.
A dynamic DNS error occurred. The IPv6 address and host name were not
updated. Check if the address of the DNS server has been correctly set on the
machine. Also check if the DNS server supports dynamic update for IPv6
addresses.
Description and Remedy