Xerox WorkCentre 5230A System Administration Manual page 242

8 Printer Environment Settings
2.
Press the <Log In/Out> button on the control panel, and then type in the System
Administrator login ID to enter the System Administration mode.
NOTE: The passcode may also be required depending on the machine configuration.
3.
Press the <Machine Status> button on the control panel, and then select the
[Tools] tab on the screen.
4.
Select [System Settings] in the menu at the left side of the screen.
5.
Select [Connectivity & Network Setup] in the [Group] menu.
6.
Select [Protocol Settings] in the [Features] menu.
7.
Under [TCP/IP - IP Mode], select [IPv4 Mode], [IPv6 Mode], or [Dual Stack].
When [IPv4 Mode] or [Dual Stack] is selected in step 7
8.
Select [IPv4 - IP Address Resolution], and then [Change Settings].
9.
Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP],
[DHCP/Autonet], and [STATIC], and then select [Save].
NOTE: Use the DHCP server together with the Windows Internet Name Server
(WINS) server.
If you selected [STATIC] in step 9, then proceed to step 10 to configure the protocol
settings. Otherwise, proceed to step 16.
10.
Select [IPv4 - IP Address], and then [Change Settings].
11.
Use the keypad on the screen to enter an IP address for the machine in the format
"xxx.xxx.xxx.xxx". When you have finished entering all values, select [Save].
12.
Select [IPv4 – Subnet Mask], and then [Change Settings].
13.
Using the same method as in step 11, enter a subnet mask.
14.
Select [IPv4 – Gateway Address], and then [Change Settings].
15.
Using the same method as in step 11, enter a gateway address.
NOTE: If you do not wish to set the gateway address, leave this field blank.
16.
Select [IPv4 – IP Filter], and then [Change Settings].
17.
Select [Enabled] to filter access to the machine.
NOTE: If you do not wish to use the IP filter feature, select [Disabled].
NOTE: Use CentreWare Internet Services to register the IP addresses which are not
allowed to access the machine. Refer to
18.
When you have finished establishing TCP/IP, select [Close] on the [Protocol
Settings] screen.
When [IPv6 Mode] or [Dual Stack] is selected in step 7
8.
Set [IPv6 Address Manual Configuration].
NOTE: Select [Enabled] when the machine is connected to a network on which IPv6
stateless address autoconfiguration is disabled, or when you want to set a static IPv6
address.
If you selected [Enabled] in step 8, proceed to step 9. Otherwise, proceed to step 15.
9.
Select [Manually Configured IPv6 Address], and then [Change Settings].
242
CentreWare Internet Services on page 149
.