Allocate Memory; Postscript Memory - Xerox WorkCentre 5230A System Administration Manual

Allocate Memory

This feature allows you to specify memory capacities required for printing and for the
receiving buffer for each interface.
1.
Select [Allocate Memory] in the
[Features] menu.
2.
Change the required settings.
Use the scroll buttons to switch
between screens.
3.
Select [Close].

PostScript Memory

Specifies the PostScript memory capacity within the range of 16.00-96.00 MB in 0.25
MB increments using the scroll buttons or the numeric keypad. The currently available
memory will be displayed at the top of the screen with the following message: "Memory
Available: XXX MB."
Job Ticket Memory (WorkCentre 5225A/5230A)
Specifies the job ticket memory capacity within the range of 0.25-8.00 MB in 0.25 MB
increments using the scroll buttons or the numeric keypad. The currently available
memory will be displayed at the top of the screen with the following message: "Memory
Available: XXX MB."
Receiving Buffer - USB
Specifies the input buffer memory capacity for the USB interface within the range of 64-
1024 KB in 32 KB increments using the scroll buttons or the numeric keypad. The
currently available memory will be displayed at the top of the screen with the following
message: "Memory Available: XXX MB."
Receiving Buffer - LPD
Specifies the input buffer memory capacity for the LPD interface. The currently
available memory will be displayed at the top of the screen with the following message:
"Memory Available: XXX MB."
NOTE: When printing with the receiving buffer spooling set to [Spool to Memory] or
[Spool to Hard Disk], each page within a job is printed in the sequence assigned by the
operating system. However, sometimes pages between different jobs may not be
printed in the intended sequence if, for example, printing multiple copies of a single 1-
page job. In this case, set spooling to [No Spooling], the default, to maintain the
intended printing sequence.
NOTE: If [Job Submission Order] is selected under [LPD Print Queue] in [Other
Settings], this setting is fixed to [Spool to Hard Disk].
• No Spooling
Specifies no spooling. Allows you to change the input buffer memory capacity within
the range of 1024-2048 KB in 32 KB increments using the scroll buttons or the
numeric keypad.
• Spool to Memory
Specifies spooling to memory. Allows you to change the input buffer memory
capacity within the range of 0.50-32.00 MB in 0.25 MB increments using the scroll
buttons or the numeric keypad.
System Settings
101