Xerox WorkCentre 5230A System Administration Manual page 378

15 Problem Solving
The specified transmission
speed is different from the
transmission speed of the
network.
The client and machine are in
different rings connected via
a bridge, and the source
routing is inactivated.
The data format of the print
job does not match the print
environment of the client
(print data sent from the
client contains TBCP).
The data format of the print
job does not match the print
environment of the client
(print data sent from the
client is in the binary
notation).
Print paper is out.
The selected transport
protocol does not match the
client.
When the required printing result is not obtained
The specified print language
is different from the print
language of the print data.
378
Cause Confirmation Method
Check whether the
transmission speed is
specified correctly.
Check whether the source
routing is specified correctly.
Check the paper refilling
message on the control
panel.
Check the transport protocol
selected from the control
panel.
Cause Confirmation Method
Check the specified print
language and the print
language of the print data.
Specify the correct
transmission speed.
Activate the source routing.
Specify PSASC as the printer
name.
–
Set the logical printer name
to PSBIN to print a binary file
in the PostScript language.
–
Load the paper into the paper
tray. When changing the
paper size, specify the new
size, if required.
Select the transport protocol
matching the client.
Specify a print language
matching that of the print
data.
Action
Action