Xerox WorkCentre 5230A System Administration Manual page 375

Cause
The number of print queues
assigned exceeds the
maximum number that the
machine can support.
No slave file server is
specified (bindery service
mode).
Incorrect printer type.
The setting for the slave file
server is incorrect (bindery
mode).
The actual number of the
page of the print job is
different from the page
number set in the machine.
The IPX checksum is set to
an invalid level.
The NCP packet signature is
set to an invalid level.
The default machine name is
invalid.
No directory tree name is
specified.
No context is specified.
Another printer object has
been connected.
The file server goes down.
Confirmation Method
Use NWADMIN or
PCONSOLE to check
whether the required print
queue is assigned to the
machine.*
Use PCONSOLE to check
whether a slave file server is
registered.*
Use PCONSOLE to check
the printer type.*
Use PCONSOLE to check
the setting.*
Use NWADMIN to check
whether the starting paper
number is the same as that of
the print job.*
Use the Set command on the
file server console to check
whether the IPX checksum is
set to level 2.
Use the Set command on the
file server console to check
whether the NCP packet
signature is set to level 3.
Print the System Settings
List, and then check that the
6 least significant digits of the
Ethernet address are correct.
Print the System Settings
List, and then check that a
tree name is specified.
Print the System Settings
List, and then check that a
context is specified.
Use NWADMIN to check that
the object is correctly
assigned to the required print
server.*
Select [Network
Neighborhood] of Windows to
search for the file server.
Network-related Problems
Action
Re-send the print job to the
print queue assigned to the
machine.*
Use PCONSOLE to register a
slave file server.*
Use PCONSOLE to specify
[Remote Parallel, LPT1].
Then reboot the machine.*
Use PCONSOLE to specify
the correct setting.*
Use NWADMIN or
PCONSOLE to match the
[Starting paper] number with
the paper number of the print
job.*
Enter the following command
on the file server console to
set the IPX checksum to level
0 or level 1.
Set Enable IPX Checksum =
x (x: 0 or 1)
Enter the following command
on the file server console to
set the NCP packet signature
to level 0, 1, or 2 and then
restart the file server.
set NCP Packet Signature
Option = x (x: 0, 1, or 2)
Specify the correct Ethernet
address, or assign a name
other than the default.
Specify a tree name.
Specify a context.
Use PCL Print Driver CD-
ROM or CentreWare Internet
Services to specify the
correct file server name, tree
name, context name, and
active mode.
Activate the file server.
375