Ethertalk; Information Checklist; Ethertalk Environments - Xerox WorkCentre 5230A System Administration Manual

EtherTalk

This section explains how to set up the machine to operate on an EtherTalk network.
The following information is provided:
Information Checklist – page 257
EtherTalk Environments – page 257
EtherTalk Installation – page 258
Installation Procedure – page 258
Network Communication Setup – page 258
Computer Setup – page 258
Test Print – page 259

Information Checklist

Before installing EtherTalk on the machine, make sure that the following items are
available or have been performed.
An existing operational EtherTalk network with Macintosh workstations
equipped with Ethernet network interface cards is required. These
procedures are not designed to install an EtherTalk network.
Macintosh System versions 7.5 or later, 8.x, 9.x, or Mac OS X 10.x
Test the machine to make sure that it is fully installed and functioning
correctly.
Install the Adobe PS print driver, or PPD (optional).
If problems are encountered during the machine installation, refer to
on page 349

EtherTalk Environments

System configuration
As the machine supports EtherTalk protocol, you can print from a Macintosh.
NOTE: You will need the optional PostScript Kit to use EtherTalk for printing.
Target computers
The machine supports a Macintosh or Power Macintosh with the following OS:
• Mac OS 7.5 or later, 8.x, 9.x, or Mac OS X 10.x
Item
.
EtherTalk
By
Customer
Customer
Customer
Customer
Problem Solving
257