Operator Advisories - Toro Groundsmaster 4500-D Series Service Manual

Operator Advisories

Advisory Advisory Name
B2004 START DENIED
B2005
START DENIED
B2008 START DENIED
B2009 START DENIED
B200D START DENIED
B2013 START DENIED
B2015 START DENIED
B2026 ENGINE RPM RESTRICTED
B2027 ENGINE SHUTDOWN
B2028
ENGINE DERATE
B2030 COOLING MAXIMIZED
B2031 ENGINE WARM UP
B211D CRUISE DENIED
B211E CRUISE DENIED
B211F CRUISE DENIED
B2133 RANGE LO DENIED
B2155
TRACTION DISABLED
B2159 TRACTION DISABLED
B2168 TRACTION TEACH DENIED
B216A TRACTION ADVISORY
B2403 DECK LOWER DENIED
Troubleshooting:
Remove all jewelry, especially rings and watches, before doing any
electrical troubleshooting or testing. Also, disconnect the battery
cables unless the test requires battery voltage.
For effective troubleshooting and repairs, you must have a good understanding
of the electrical circuits and components used on this machine (see
Electrical System (page
If the machine has any interlock switches by−passed, reconnect the switches for
safety and efficient troubleshooting.
Note: Check the InfoCenter Display for possible operator advisories or faults
whenever diagnosing machine electrical problems.
The list below identifies the operator advisories that are generated by the TEC
controller. An advisory will be displayed on the InfoCenter Display. Typically, an
advisory can be eliminated with a change in machine controls by the operator.
PTO switch engaged
Out of seat and parking brake
disengaged
Traction pedal engaged
Engine running
Teach engaged
Fault(s) active
Deck switch engaged
Cold hydraulic fluid
Engine too hot
Engine too hot
System too hot
Cold hydraulic fluid
Ground speed too slow
Traction pedal in reverse
Brake applied
Not in neutral
Parking brake engaged
Out of seat
Engine running
Traction pedal sensor needs
calibration
Not in neutral
CAUTION
6–1)).
Cause
Page 3–10
Chapter 6:
InfoCenter Message | Corrective
Action Required
To start | Disengage PTO
To start | Must be seated or set
parking brake
To start | Move traction pedal to
neutral
To start | Engine Running
Complete teach sequence
To start | Resolve active faults
To start | Disengage Deck Switch
Engine RPM Restricted | Let
hydraulic oil warm
Engine | Let engine cool
Engine | Let engine cool
Check cooling system
Let hydraulic oil warm
To set cruise | Increase ground
speed
Move traction pedal
Release brake
Return traction pedal to neutral
For traction | Release parking brake
For traction | Operator must be
seated
Traction pedal | Engine running
Traction pedal | Calibrate
Return traction pedal to neutral
Groundsmaster ® 4500-D/4700-D
19245SL Rev A