Toro Groundsmaster 4500-D Series Service Manual page 424

Removal (Figure 292)
Installation (Figure
Chassis: Service and Repairs
1. Park machine on a level surface, lower cutting decks, stop engine, apply
parking brake and remove key from the ignition switch.
2. Disconnect seat electrical connector from machine wire harness.
3. Support console arm assembly to prevent it from shifting.
4. Remove flange nut (item 29) and carriage screw (item 28) that secure
support bracket (item 24) to support channel (item 22).
5. Remove cap screw (item 30) that secures console arm support (item 23) to
coupling nut (item 32).
6. Remove cap screw (item 27), flat washer (item 11), spacer (item 26) and seat
belt buckle (item 31) from seat and console arm support (item 23).
Make sure to not damage the electrical harness or other parts while
moving the console arm assembly.
7. Carefully move console arm assembly away from seat.
8. Remove four (4) torx head screws that secure seat to seat suspension
(Figure 293). Note that the screw near the seat adjustment handle is longer
than the other three (3) screws.
9. Lift seat from seat suspension and remove from machine.
3
25 N·m
(18 ft−lb)
g276884
1. Seat
2. Suspension assembly
292)
1. Carefully position seat to seat suspension.
2. Secure seat to seat suspension with four (4) torx head screws
Make sure that longer screw is positioned near the seat adjustment handle.
Torque screws 25 N·m (18 ft-lb).
IMPORTANT
1
4
2
Figure 293
3. Screw (M8x12) (3 used)
4. Screw (M8x16)
Page 8–20
(Figure 293).
Groundsmaster ® 4500-D/4700-D
19245SL Rev A