Toro Groundsmaster 4500-D Series Service Manual page 428

Disassembly (Figure
Assembly (Figure 295)
Chassis: Service and Repairs
295)
1. Park machine on a level surface, lower cutting decks, stop engine, apply
parking brake and remove key from the ignition switch.
2. Remove operator seat from seat suspension (see
8–19)).
3. Disconnect seat suspension electrical connector from machine wire harness.
g310578
1. Seat frame
2. Flange nut (4 used)
3. Seat plate
4. If the air spring assembly (item 6) or base plate (item 37) requires removal,
remove seat suspension from seat plate
A. Raise and support seat plate assembly.
B. Remove four (4) flange head screws and flange nuts that secure seat
suspension to seat plate.
C. Remove seat suspension from machine.
5. Remove seat suspension components as needed using
guide.
1. Install all removed seat suspension components using
2. If seat suspension was removed from seat platform
A. Position seat suspension onto seat plate.
B. Secure seat suspension to seat plate with four (4) flange head screws
and flange nuts.
3. Install operator seat to seat suspension (see
Figure 296
4. Seat suspension
5. Flange screw (4 used)
(Figure
Page 8–24
Operator Seat (page
296):
Figure 295
Figure 295 as a guide.
(Figure 296):
Operator Seat (page 8–19)).
Groundsmaster ® 4500-D/4700-D
19245SL Rev A
as a