Lift Arms For Cutting Decks #1, #4 And #5 - Toro Groundsmaster 4500-D Series Service Manual

Lift Arms for Cutting Decks #1, #4 and #5

g310462
1. Flat washer
2. Flange nut
3. Lift arm (#1 deck)
4. Lift cylinder pin
5. Flange head screw
6. Flange nut
7. Cap screw
8. Lift cylinder (#4 and #5 decks)
9. Lift cylinder (#1 deck)
10. Thrust washer (2 used per arm)
11. Lock nut
12. Pivot pin
Removal (Figure 285)
Chassis: Service and Repairs
13. Slotted roll pin
14. Lift cylinder pin
15. Flange nut
16. Washer head screw
17. Skid plate
18. Lift arm (#4 deck)
19. Cap screw
20. Carrier pivot shaft
21. Front carrier frame
22. Grease fitting
23. Carriage bolt
24. Switch bracket
1. Park machine on a level surface, lower cutting decks, stop engine, engage
parking brake and remove key from the ignition switch.
2. Remove cutting deck assembly from lift arm (see Cutting Deck Operator's
Manual).
Figure 285
25.
26.
27.
28.
29.
30.
31.
32.
33.
34.
35.
Page 8–12
Deck position switch
Switch plate
Lock nut
Bumper support bracket
Bumper
Lift arm (#5 deck)
Lock nut
Grease fitting
Thrust washer
Flange bushing (2 used per arm)
Bushing (2 used per arm)
Groundsmaster ® 4500-D/4700-D
19245SL Rev A