Toro Groundsmaster 4500-D Series Service Manual page 299

Settings Screen (continued)
Groundsmaster ® 4500-D/4700-D
19245SL Rev A
6
4
g309320
1. Settings menu
2. Settings items
3. Current setting
The settings screen identifies the InfoCenter language and decks (English or
Metric). The settings screen also allows the operator to customize the backlight
(brightness) and contrast settings for the InfoCenter display.
If either the backlight (brightness) or contrast items are selected, the center
button (−) or right button (+) can be used to change the display settings.
Protected menus allows the machine PIN to be entered so that hidden machine
service screen items can be viewed and modified. The protected service
items includes service intervel reset, traction pedal sensor calibration, traction
pump calibration, cooling fan reversal demonstration and exhaust system DPF
regeneration (Tier4 engines). If the protect settings is ON (see below), auto
idle, mow speed, transport speed and counterbalance are also included in the
protected menu.
To allow access to the protected menu items, enter the four (4) digit pin PIN
using the center and right InfoCenter buttons. After PIN has been entered, a
check mark should be visible above center InfoCenter button. Press center
button and the InfoCenter display screen should indicate PIN in the upper right
hand corner if the correct PIN number was entered. Use back button to return to
Settings menu. The protected menu items should be available in the Service
menu and can be changed as long as the ignition switch remains in RUN.
Note: The initial PIN will either be 1234 or 0000. If the PIN has been changed
and is forgotten, a temporary PIN can be obtained from your Toro distributor.
Protect settings allows the settings for auto idle, mow speed, transport speed
and counterbalance to be hidden so they cannot be changed unless the PIN
is entered. If the protect settings is ON, these settings will not be seen when
using the InfoCenter until the protected menus is selected and the chosen PIN is
entered. If protect settings is OFF (default setting), settings for these functions
will be visible on the InfoCenter and can be adjusted by the operator.
Mow Speed allows the maximum traction speed to be adjusted when in LOW
(mow) speed. Adjustments will be listed as a percent.
Trans. (Transport) Speed allows the maximum traction speed to be adjusted
when in HI (transport) speed. Adjustments will be listed as a percent.
1
Mow Speed:
2
Trans. Speed:
Counter Balance:
+
6
4
Figure 177
4.
5.
6.
Page 6–17
3
100%
70%
Med.
5
Increase setting
Decrease setting
Back button
Electrical System: General Information