Toro Groundsmaster 4500-D Series Service Manual page 216

Removal (Figure 108) (continued)
Manifold Service
Hydraulic System: Service and Repairs
4. Disconnect hydraulic lines from manifold and put caps or plugs on open
hydraulic lines and fittings.
5. Remove two speed shift manifold from the frame using
6. If hydraulic fittings are to be removed from control manifold, mark fitting
orientation to allow correct assembly. Remove fittings from manifold and
discard O-rings.
g308770
1. Manifold body
2. Tee fitting w/O-ring
3. Straight fitting w/O-ring
g308771
For cartridge valve service procedures, see Control Manifold Cartridge Valve
Service in this section. Refer to
fitting installation torque.
Figure 109
4. Check adapter w/O-ring
5. Screw (2 used)
6. Solenoid valve
Figure 110
CHECK VALVE ADAPTER
Figure 109 for cartridge valve and hydraulic
Page 5–114
Figure 108 as guide.
Groundsmaster ® 4500-D/4700-D
19245SL Rev A