Toro Groundsmaster 4500-D Series Service Manual page 267

Removal (Figure 148) (continued)
Installation (Figure
Groundsmaster ® 4500-D/4700-D
19245SL Rev A
6. If necessary, remove fittings from manifold and discard O-rings
and Figure 150).
148)
When installing orifice in manifold, make sure that orifice is flat in
the base of the manifold port. Manifold damage is possible if the
orifice is cocked in the cavity.
1. If fittings were removed from junction manifold, lubricate and place new
O-rings onto fittings. Install fittings into manifold openings making sure that
orifice is correctly placed before threading fitting into manifold. Tighten fittings
(see Installing the Hydraulic Fittings (SAE Straight Thread O-Ring Fittings)
(page 5–9)). Refer to
2. Install hydraulic manifold to the frame using
3. Remove caps and plugs from fittings and hydraulic lines. Properly connect
hydraulic lines to manifold (see
Face Seal) (page 5–7)).
IMPORTANT
Figure 149 and Figure 150
Installing Hydraulic Hoses and Tubes (O-Ring
Page 5–165
(Figure 149
for fitting installation torque.
Figure 148 as guide.
Hydraulic System: Service and Repairs