Manifold Service (continued)
Installation
(Figure
Groundsmaster
®
4500-D/4700-D
19245SL Rev A
Note: The check valve adapter used in the two speed shift manifold allows free
flow toward the manifold and prevents flow away from the manifold
108)
1. If fittings were removed from control manifold, lubricate and place new
O-rings onto fittings. Install fittings into manifold ports using marks made
during the removal process to properly orientate fittings. Tighten fittings
(see
Installing the Hydraulic Fittings (SAE Straight Thread O-Ring Fittings)
(page
5–9)).
2. Install two speed shift manifold to the frame using
3. Remove caps and plugs from fittings and hydraulic lines. Using labels placed
during manifold removal, properly connect hydraulic lines to manifold (see
Installing Hydraulic Hoses and Tubes (O-Ring Face Seal) (page
4. Fill hydraulic reservoir with hydraulic fluid as required.
Page 5–115
(Figure
Figure 108
as guide.
5–7)).
Hydraulic System: Service and Repairs
110).