Toro Groundsmaster 4500-D Series Service Manual page 383

Installation
Groundsmaster ® 4500-D/4700-D
19245SL Rev A
2
1
g276514
1. Axle case
2. Bevel gear case
1. Coat new shaft seal with grease and install in axle case as shown
250).
6
5
g276515
1. Axle case cover
2. Lower bevel gear
3. Bevel gear shaft
4. Lower bearing
2. Install the lower bevel gear and bevel gear shaft in the axle case cover.
Coat a new O-ring with grease and install the axle case cover
Tighten cover screws from 23 to 27 N·m (17 to 20 ft-lb).
3. Slide the bevel gear case over the bevel gear shaft and install the bevel
gear and collar. Make sure the bevel gear shaft is completely seated in the
upper and lower bearings
3
Figure 250
3. Shaft seal
8
2
4
Figure 251
5. Upper bevel gear
6. Collar
7. Upper bearing
8. Knuckle pin
(Figure 251).
Page 7–25 Axles, Planetaries and Brakes: Service and Repairs
(Figure
7
3
1
(Figure 251).