Toro Groundsmaster 4500-D Series Service Manual page 440

Disassembly (Figure
Assembly (Figure 300)
Cutting Decks: Service and Repairs
300) (continued)
g277084
1. Bearing
2. Spacer ring
3. Large snap ring
Note: A replacement spindle bearing set contains two (2) bearings, a spacer
ring and a large snap ring (items 1, 2 and 3 in
be purchased separately. Do not mix bearing set components from one deck
spindle to another.
Note: A replacement bearing spacer set includes the inner spacer and outer
spacer (items 4 and 5 in
deck spindle to another.
If new bearings are installed into a used spindle housing, it may not
be necessary to replace the original large snap ring. If the original
large snap ring is in good condition with no evidence of damage (e.g.
spun bearing), leave the snap ring in the housing and discard the
large snap ring that comes with the new bearings. If the large snap
ring is found to be damaged, replace the snap ring.
1. If large snap ring was removed from spindle housing, install snap ring into
housing groove. Make sure snap ring is fully seated in groove.
2. Install outer bearing spacer into top of spindle housing. The spacer should fit
against the large snap ring.
1
2
3
1
Figure 301
4. Inner bearing spacer
5. Outer bearing spacer
Figure
Figure 301). Do not mix bearing spacers from one
IMPORTANT
Page 9–8
5
301). These parts cannot
Groundsmaster ® 4500-D/4700-D
19245SL Rev A