Toro Groundsmaster 4500-D Series Service Manual page 415

Disassembly (Figure
Assembly (Figure 283)
Groundsmaster ® 4500-D/4700-D
19245SL Rev A
283)
1. Park machine on a level surface, lower cutting decks, stop engine and
engage parking brake. Remove key from ignition switch.
2. Remove two (2) flange head screws (item 8) and then cover plate (item 7)
from outside of console arm. Locate and retrieve two (2) flange spacers
(item 36).
3. At front of console arm, remove screw (item 5) and lock nut (item 6) that
secure console arm covers to each other.
4. Remove five (5) washer head screws (item 4) that secure each cover to
console arm panel.
5. Remove console arm covers from machine. As LH cover (item 2) is removed
from console arm, unplug wire harness connector from headlight switch.
6. Remove electrical components from console arm as needed using
283 as a guide.
7. If necessary, remove console panel and supports from machine using
283 and Figure 284
1
6
5
12
11
g276873
1. Flat washer
2. Seat belt buckle
3. Coupling nut
4. Spacer
5. Carriage screw (5 used)
6. Cap screw
1. Install all removed electrical and console arm components using
and Figure 284 as guides.
2. Position covers to console arm. As LH cover (item 2) is placed, plug wire
harness connector to headlight switch.
3. Secure each cover to console arm with five (5) washer head screws (item
4). Install screw (item 5) and lock nut (item 6) to secure covers at front of
console arm.
4. Position cover plate and flange spacers to outside of console arm. Secure
with two (2) flange head screws.
as guides.
7
3
4
2
8
1
9
5
10
11
Figure 284
7. Screw
8. Arm support
9. Hex nut
10. Support bracket
11. Flange nut (5 used)
12. Support channel
Page 8–11
Figure
Figure
Figure 283
Chassis: Service and Repairs