Toro Groundsmaster 4500-D Series Service Manual page 418

Installation (Figure
Chassis: Service and Repairs
285) (continued)
g310463
1. Supply hose
2. Return hose
6. If lift arm for either deck #4 or #5 was removed, slide hydraulic hoses through
the hose retaining loop on the lift arm. Remove caps and plugs from hydraulic
hoses and fittings and install hoses to the deck motor
sure that deck is fully lowered to the ground before tightening hoses.
7. Lubricate lift arm and lift cylinder grease fittings after assembly is complete.
8. After assembly, raise and lower the cutting deck to verify that hydraulic hoses
and fittings do not contact anything.
Figure 287
3. Case drain hose
4. Hose retaining loop
Page 8–14
(Figure 287). Make
Groundsmaster ® 4500-D/4700-D
19245SL Rev A