Toro Groundsmaster 4500-D Series Service Manual page 295

Faults Screen
Groundsmaster ® 4500-D/4700-D
19245SL Rev A
g316092
1. Fault menu
2. Fault items
3. Move to menu items
The faults screen (Figure
occurred since the faults were last cleared from the InfoCenter. The faults will
be identified by a fault number and when the fault occurred. Faults that might
occur on the machine are listed in Fault Codes in the Troubleshooting section of
this chapter.
After entry of the PIN code, the InfoCenter fault log can be cleared by selecting
the clear system faults menu item. The cleared faults will be removed from the
Info- Center list but will be retained in the TEC controller memory.
If a fault occurs during machine use, there may be a change in machine
functionality due to the fault. Should there be machine operation issues due to a
fault, a first step to remedy the issue would be to disengage the cutting decks,
release the traction pedal, turn the ignition switch OFF and allow all machine
functions to stop. Then, attempt to restart the machine to see if operation has
returned to normal. Some faults will be reset during the restart and will then
allow normal function. If a fault continues to occur, further system evaluation and
possible component repair or replacement will be necessary.
To return to the main menu screen from the faults screen, press the back button
(left button).
1
Faults
2 C1134 −57.3 Ago
Clear System Faults
5
3
5
3
Figure 173
4. Choose menu item
5. Back button
173) will list all machine electrical faults that have
Page 6–13
4
Electrical System: General Information