Troubleshooting; Operator Advisories - Toro Reelmaster 5410 Series Service Manual

Troubleshooting

Operator Advisories

Electrical System: Troubleshooting
Remove all the jewelry, especially rings and watches, before doing
any electrical troubleshooting or testing. Disconnect the battery
cables unless the test requires battery voltage.
For the effective troubleshooting and repairs, you must have a good
understanding of the electrical circuits and components that are used on this
machine; refer to the Electrical Schematic and Wire Harness Drawings/Diagrams
in Appendix A (page A–1).
If the machine has any interlock switches that are bypassed, connect the
switches for the correct troubleshooting and safety.
Note: Use the InfoCenter display when troubleshooting a Reelmaster electrical
problem.
If controls are not selected properly to allow certain machine operations, the
InfoCenter indicator light will illuminate and an advisory will be displayed on the
InfoCenter display, refer to
Advisory numbers, descriptions, and reason for advisories are listed in the
Advisories Table (page
machine settings.
Advisories Table
Advisory Advisory Description
Number
160 Inhibit start
161 Inhibit PTO
162 Inhibit cutting unit lower
169 Engine shutdown
170 Recycle key switch
CAUTION
Operator Advisory Screen (page
7–26). Some advisories can be caused by several
Neither seat occupied nor parking brake
applied
Traction pedal is not in N
Wait to start until system functions have been
initialized
Joystick is in R
Joystick is in L
No operator in seat
Engine coolant temperature is excessive
Mow speed limiter is in T
No operator in seat
Parking brake is applied
Engine coolant temperature is excessive
Engine oil pressure is low
Engine starter motor has been engaged for
30 seconds
Page 7–26
7–13).
Possible Reason for Advisory
position
EUTRAL
position
AISE
position
OWER
RANSPORT
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
position