Steering Cylinder
g308934
1.
Steering cylinder
2.
Ball joint
3.
Ball joint
4.
Retaining ring
5.
Grease fitting
6.
Grease fitting
Removal
(Figure
134)
Hydraulic System: Service and Repairs
7.
90º hydraulic fitting
8.
O-ring
9.
O-ring
10.
Drive axle assembly
11.
Ball joint spacer
12.
Axle washer
1. Park machine on a level surface, lower cutting decks, stop engine, engage
parking brake and remove key from the ignition switch.
2. Read the
General Precautions for Removing and Installing Hydraulic System
Components (page
3. To prevent contamination of hydraulic system during steering cylinder
removal, thoroughly clean exterior of steering cylinder.
4. Remove hydraulic hoses from steering cylinder. Label the hydraulic hoses to
show their correct position on the steering cylinder for assembly purposes.
5. Put caps or plugs on disconnected hoses and fittings to prevent
contamination.
Figure 134
13.
14.
15.
16.
5–87).
Page 5–142
Slotted hex nut
Cotter pin
Hydraulic hose
Hydraulic hose
Groundsmaster
®
4500-D/4700-D
19245SL Rev A