Differential Shafts - Toro Groundsmaster 4500-D Series Service Manual

Differential Shafts

Removal
Groundsmaster ® 4500-D/4700-D
19245SL Rev A
47 to 56 N·m
(35 to 41 ft-lb)
g276519
1. Cap screw (4 used)
2. Lock nut (2 used)
3. Lock washer (2 used)
4. Axle support
The following procedures assume the rear axle assembly has been removed
from the machine.
Do not interchange right and left differential shaft assemblies.
1. Remove the mounting screws, nuts and lock washers. Remove the bevel
gear case/axle case assembly and O-ring from the axle support
2. Mark and pull the differential shaft assembly from the axle support.
g276521
1. Retaining ring
2. Bevel gear
3. Differential shaft
3. Remove the retaining ring and bevel gear
4. Drive the differential shaft out of the bearings. Remove the bearings and
bearing shims.
1
4
2
3
7
Figure 255
5. Bevel gear/axle case assembly
6. O-ring
7. Stud (2 used)
IMPORTANT
6
3
Figure 256
4. Bearing
5. Bearing shims
6. O-ring
(Figure
Page 7–29 Axles, Planetaries and Brakes: Service and Repairs
47 to 56 N·m
(35 to 41 ft-lb)
5
6
(Figure
5
4
2
1
256).
255).