Toro Groundsmaster 4500-D Series Service Manual page 363

Brake Assembly Removal
Brake Assembly Installation
Groundsmaster ® 4500-D/4700-D
19245SL Rev A
(Figure 231) (continued)
4. Remove front wheel assembly.
5. Remove hydraulic wheel motor (see
6. Disconnect brake cable from pull rod on brake
Note: Be careful to not drop splined brake shaft as brake assembly is
removed.
7. Support brake assembly and remove flange head cap screws (item 11)
securing brake assembly to frame. Remove brake assembly.
8. Remove splined brake shaft.
9. Remove and discard gasket (item 12). Make sure that all gasket material and
sealant is removed from both the brake and the planetary assembly.
10. Complete brake inspection and repair (see
(page 7–7)).
(Figure 231)
3
g276520
1. Splined brake shaft step
2. Hydraulic motor end
g310088
1. Brake cable
Note: The stepped end of the splined brake shaft must be aligned toward the
hydraulic wheel motor
Front Wheel Motors (page
Figure 232
3. Planetary assembly end
Figure 233
2. Brake pull rod
(Figure 232).
Page 7–5 Axles, Planetaries and Brakes: Service and Repairs
5–118)).
(Figure 233).
Brake Inspection and Repair
2
1