Panasonic FP Series Programming Manual page 817

Hide thumbs Also See for FP Series:

Table of Contents

Data transfer within the PLC

The two 16-bit data or two 16-bit equivalent constants specified by s1 and s2 are copied to the

32-bit area specified by d when the trigger turns ON.

This instruction also exists as a P instruction (for FP2/2SH, FP3/5, FP10/10SH PLC types), which

is only executed at the rising edge of the EN trigger. Select [Insert P instruction] from the

"Instructions" pane if you require a P instruction. To facilitate reuse, the instruction then appears

under "Recently used" in the pop-up menu. Press <Ctrl>+<Shift>+<v> within the programming

area to open the list of recently used elements.

Availability of F7_MV2 (see page 1326)

To transfer three 16-bit data types, use either the F190_MV3 (see page 853) or

P190_MV3 instruction.

In this example, the same POU header is used for all programming languages. For an example

using IL (instruction list), please refer to the online help.

All input and output variables used for programming this function have been declared in the POU

In this example the input variables input_value_1 and input_value_2 are declared. However, you

can write constants directly at the input contact of the function instead.

When the variable start is set to TRUE, the function is carried out.

Two 16-bit data move

source 16-bit area

destination 32-bit area

dec. or hex.