Panasonic FP Series Programming Manual page 857

Hide thumbs Also See for FP Series:

Table of Contents

Data transfer within the PLC

The function copies three 32-bit data values at inputs s1, s2 and s3 to an ARRAY with three

elements that is returned at output d.

This instruction also exists as a P instruction (for FP2/2SH, FP3/5, FP10/10SH PLC types), which

is only executed at the rising edge of the EN trigger. Select [Insert P instruction] from the

"Instructions" pane if you require a P instruction. To facilitate reuse, the instruction then appears

under "Recently used" in the pop-up menu. Press <Ctrl>+<Shift>+<v> within the programming

area to open the list of recently used elements.

Availability of F191_DMV3 (see page 1322)

To transfer two 32-bit data types, use either the F8_DMV2 (see page 817) or

P8_DMV2 instruction.

ARRAY [0..2]

The variables s1, s2, s3 and d have to be of the same data type.

In this example, the same POU header is used for all programming languages. For an example

using IL (instruction list), please refer to the online help.

All input and output variables used for programming this function have been declared in the POU

When the variable start is set to TRUE, the function is carried out.

Three 32-bit data move

source 32-bit area

destination, lower 32-bit area of 96-bit area

dec. or hex.