Panasonic FP Series Programming Manual page 482

Hide thumbs Also See for FP Series:

Table of Contents

The function searches for the value specified at input s1 in a block of 32-bit areas whose beginning

is specified at input s2 and whose end is specified at input s3.

Value searched for

The number of data items that match s1 is stored in special data register DT90037.

The relative position of the first matching data item, counting from the starting 32-bit area s2, is

stored in special data register DT90038.

This instruction also exists as a P instruction (for FP2/2SH, FP3/5, FP10/10SH PLC types), which

is only executed at the rising edge of the EN trigger. Select [Insert P instruction] from the

"Instructions" pane if you require a P instruction. To facilitate reuse, the instruction then appears

under "Recently used" in the pop-up menu. Press <Ctrl>+<Shift>+<v> within the programming

area to open the list of recently used elements.

Availability of F97_DSRC (see page 1326)

The adresses of the variables at inputs s2 and s3 must be of the same adress type.

32-bit table data search

32-bit table data

32-bit area or equivalent constant to store the value

searched for

starting 32-bit area of the block

ending 32-bit area of the block

for an instant

 the address of the variables at outputs

Arithmetic instructions

dec. or hex.