Table of Contents
Advertisement
1
K Type
2
Temperature
-100 °C to
3
of terminal to
Temperature
4
1000 °C
of terminal
5
ON
Off
On
1
2
3
4
5
1. No averaging: Conversion data is set for the specified input contact point
area for each A/D conversion, on each channel.
2. With averaging: on each channel, for each A/D conversion, the maximum and
minimum values from the data of the last ten times are excluded, and the
data from the other eight times is averaged, and the result set.
3. If a thermocouple setting is used, averaging is carried out, regardless of the
switch settings.
4. After turning on the analog unit, 20 minutes are required for the transient
state to reach a measurement accuracy of 99%. During this time, deviations
of 10°C can occur.
measurement accuracy
99%
5. The DIP switch settings are read once at switching the CPU power to ON.
Changes of the DIP switches are not recognized until the next reset of the
CPU (power OFF ON).
Thermocouples, see notes 3, 4
J Type
Temperature
-100 °C to
of terminal to
Temperature
750 °C
of terminal
Off
On
Off
On
Off
±10 °C
20 min
Analog unit instructions
T Type
Temperature
-100 °C to
of terminal to
Temperature of
350 °C
terminal
On
Off
On
Off
time
On
1093
Advertisement
Table of Contents
