Panasonic FP Series Programming Manual page 679

Conversion instructions
Operands
For
s1_Control
s2_AsciiData
n_Conversion
Method
d_BinaryData
Error flags
No. IEC address
%MX0.900.7
R9007
%MX0.900.8
R9008

Explanation of the conversion method, e.g. n_ConversionMethod = 16#0413 for
ASCII data '0123456789012'
16 # 0 4 1 3
Offset in ASCII character units (8-bit) for
Number of 16-bit (1-word) or 32-bit (2-word) units to be converted
678
Relay
WX WY WR WL
WX WY WR WL
- WY WR WL
- WY WR WL
Set
permanently
for an instant
Number of ASCII characters per
converted unit
Register content (hex.)
Character string
storing the result
16#0 to 16#F (0 to 15)
16#0 to 16#FF (0 to 255)
T/C Register
SV EV DT LD -
SV EV DT LD -
SV EV DT LD -
SV EV DT LD -
If
 there is an error in the control string
specified by s1_Control.
 normal direction (+) is specified in
s1_Control when the format is decimal.
 the number of ASCII characters per
converted unit specified by
n_ConversionMethod exceeds 4 for
16-bit data or 8 for 32-bit data when
hexadecimal format is specifed by
s1_Control.
 0 is specified for the no. of 16- or 32-bit
(1- or 2-word) units to be converted in
n_ConversionMethod.
 the number of 16- or 32-bit decimal
numbers to be converted specified by
n_ConversionMethod exceeds the area
for storing ASCII data.
 the converted result exceeds the area.
For comma-delimited data, specify the maximum
number for numeric data. For decimal ASCII data,
spaces, symbols and a decimal point are
included. The data range is restricted by the
control character string s1_Control.
3 2 3 1 3 0 3 9 3 8 3 7 3 6 3 5
'2 1 0 9 8
Constant
-
-
dec or hex
-
3 4 3 3 3 2 3 1
7 6 5 4 3 2 1'