Definity Software Reset (Recovery; Reset System 1 (Definity Warm Start; Reset System 2 (Definity Cold Start - Avaya DEFINITY ONE Installation And Upgrades

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10 555-233-109
D Recovery

DEFINITY software reset (recovery)

DEFINITY software reset (recovery)
There are severe reset levels available to restart DEFINITY software. These
resets can be user initiated with the reset system n command (where n is the
reset level). They may also be automatically initiated by system software in
response to certain error conditions.
A system is reset due to a loss of power, or through:
Reset commands entered during a SAT terminal session.
Maintenance software, from which the system can reset itself. (This
process starts when certain software and hardware errors are detected by
the software.)
!
The SAT display and circuit pack LEDs indicate the progress of the recovery
process.

Reset System 1 (DEFINITY warm start)

This recovery takes about 60 seconds.
All software is reset.
All stable phone calls remain up.
In-progress calls are dropped.
No new calls can be made during this time.

Reset System 2 (DEFINITY cold start)

The following are reset:
All software
TDM Bus
All port circuit packs
All telephone sessions are dropped. Telephones begin to reconnect to the switch
within 60 seconds.
CAUTION:
When the system is rebooted or reset at level 2, 3, 4, or 5, all voice
terminal and attendant console features are adversely affected.
Users should be advised of services that are lost and that, as a result,
must be reactivated.
Issue 6
December 2001
D-4