Complete Installation; View Leds To Determine Power And Fan Alarm State - Avaya DEFINITY ONE Installation And Upgrades

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10 555-233-109
1 Install and Cable the Cabinet

Complete installation

Complete installation
1. Disconnect the laptop.
2. Remove the RJ45 connector used to connect the laptop.
3. Insert the flash disk.
4. Set the left and right doors of the DEFINITY ONE CMC or the single door
of the Avaya IP600 RMC onto the hinge pins and close the door(s). The
doors must be closed to prevent EMI emissions. Tighten the door screws.
5. For the DEFINITY ONE CMC, set the right cover panel onto the right panel
and secure. Do not use force.
View LEDs to determine power and fan
alarm state
Use the LEDs on the front of each power unit to determine its state.
Table 1-27
output do not activate alarm status.
Table 1-27. LED and Alarm Conditions
Condition
Normal
No Input Power
One or More DC
Outputs Present
Fan Alarm
shows the LED and alarm conditions. Ring voltage and neon bus
LED status
Red off
Yellow on
Red off
Yellow off
Red on
Yellow off
Red on
Yellow off
Alarm state Fan alarm
open high
closed open
closed no state
closed low
Issue 6
December 2001
1-136