Avaya DEFINITY ONE Installation And Upgrades page 397

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10 555-233-109
A Cable Pinouts
TN760E tie trunk option settings
Cable Pinouts
This appendix provides the following information for TN760D tie trunk and
TN464GP option settings, connector and cable diagrams, and pinout charts.
''TN760E tie trunk option settings'' on page A-1
''TN464GP option settings'' on page A-4
''Connector and cable diagrams —pinout charts'' on page A-5
TN760E tie trunk option settings
The TN760E tie trunk circuit pack interfaces between 4 tie trunks and the TDM
bus. Two tip and ring pairs form a 4-wire analog transmission line. An E and M
pair are DC signaling leads used for call setup. The E-lead receives signals from
the tie trunk and the M-lead transmits signals to the tie trunk.
To choose the preferred signaling format
set the switches on the TN760D and administer the port using
A-2 and Table A-3 on page
Table A-1. Signaling formats for TN760E
Mode
E & M
E & M
Protected
Simplex
E & M
E & M
A-3.
Type
Type I Standard (unprotected)
Type I Compatible (unprotected)
Type I Compatible, Type I Standard
Type V
Type V
Type V Revised
(Table A-1 and Table A-2 on page
Issue 6
December 2001
A-1
A
A-2),
Figure A-1 on page