Laptop Configuration For Windowstm 95/98/Nt - Avaya DEFINITY ONE Installation And Upgrades

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10 555-233-109
C Miscellaneous Procedures
Installing INTUITY languages other than English
Laptop configuration for Windows
1. Right click on Network Neighborhood, and select Properties.
2. Under the Configuration tab, left click on TCP/IP Ethernet NIC card.
3. Left click on Properties.
4. Select the IP Address tab.
5. Record the IP Address and Subnet Mask , if any. These will be needed
later.
6. Change the IP Address to 192.11.13.5 and the Subnet Mask to
255.255.255.252; then click OK.
7. Click OK in the Network window.
8. When the system says to click OK for the settings to take effect, do so.
9. Click on Start, Settings, and select Control Panel.
10. Double-click on Display.
11. Select the Screen Saver tab, and set the screen saver to None until the
upgrade is completed.
!
TM
95/98/NT
NOTE:
The services laptop uses a Zircom card.
CAUTION:
If the laptop screen saver is not disabled and times out during the
upgrade, the Terminal Server
have to wait approximately 5 minutes to re-establish the connection.
The upgrade will continue without any ill effects, even though the
session has dropped.
NOTE:
TM
For Windows NT and Windows 2000
installed on the Protocols tab under Properties. Otherwise the
computer will not be recognized by the system. This will affect
mapping a drive for doing upgrades. If you connect to the AVAYA
network, you may have to disable NETBUI after you are finished
working on the system.
NOTE:
TM
For Windows NT and Windows 2000
procedure; however, the laptop my not ask to be rebooted for settings
to take effect (as in step 8, above). This should be done, in any case.
TM
session will drop. The technician will
TM
, make sure that NETBUI is
TM
, follow the above
Issue 6
December 2001
C-6