Install Cables Between Media Gateway And Mdf; Install Connector Cables Between Auxiliary Cabinet And Mdf - Avaya S8700 Installing Manual

3-Pair Modularity for Trunk Pairs for 3-Pair Tie Trunks
1 2 3 4 5 6 7 8 9 10 11 12
1 2 3 4 5 6 7 8 9 10 11 12
Figure notes
1 Green Field
2 1-Pair Jumpers

Install Cables Between Media Gateway and MDF

1 Install D rings on the wall between the cable slack manager and the terminal/connecting
blocks mounted on the MDF.
2 Install a self-adhesive port label on the back of each connector on the connector cable.
Position the labels so the media gateway connector retainers do not cover them.
At the rear of the media gateway, connect 1 end of the connector cable to the assigned
3
connector.
Route the cable down the rear of the media gateway, through the cable slack manager,
4
and to the MDF.
At the MDF, connect the other end of the cable to the assigned terminal/ connecting
5
block connector.
6 Store the cable slack in the cable slack manager.
Repeat Steps 2 through 6 until all cables are installed.
7
Install Connector Cables Between Auxiliary
Cabinet and MDF
Auxiliary equipment that connects to the MDF can be mounted inside the Auxiliary cabinet.
The equipment connects to an ED-1E1443-10 (Group 1) intraconnection panel mounted in the
cabinet. This intraconnection panel consists of a 110-type 100-pair wiring block. Auxiliary
Patch Cord/Jumper Installation and Administration
3
13 14
1 2 3 4 5 6 7 8 9 10 11 12
3 Pairs
4 Purple Field
October 2002
15 16 17 18 19 20 21 22 23 24
r758537b MMR 031496
181