Configuring The Switch; Avaya P330 Default Settings; Switch Settings - Avaya P333T User Manual

Configuring the Switch

The Avaya P330 may be configured using the text-based Command Line Interface
(CLI) utility, the built-in Avaya P330 Device Manager (Embedded Web) or
CajunView™.
For instructions on the text-based utility, see the CLI chapter.
For instructions on installation of the graphical user interfaces, see the Avaya P330
Device Manager Appendix. For instructions on the use of the graphical user
interfaces, refer to the Manager User's Guide on the Management CD.

Avaya P330 Default Settings

The default settings for the Avaya P330 switch and its ports are determined by the
Avaya P330 software. These default settings are subject to change in newer versions
of the Avaya P330 software. See the Release Notes for the most up-to-date settings.

Switch Settings

Table 4.1
Function
Avaya P330 IP address
Default gateway
VLANs
Spanning tree
Bridge priority for Spanning Tree
NTP server IP address
Timezone offset
Read-only SNMP community string
Read-write SNMP community string
Trap SNMP community string
SNMP retries number
SNMP timeout
SNMP authentication trap
CLI timeout
Avaya P333T User's Guide
Default Switch Settings
Chapter 4 Installation and Setup
Default Setting
149.49.32.134
0.0.0.0
VLAN 1
Enabled
32768
0.0.0.0
0 hours
Public
Public
Public
3
2000 Seconds
Disabled
15 Minutes
25