Saturn S300 Series Service Manual page 88

INK JET PRINTER OPERATION
System Status
Software Version
Machine ID
It is used to check the current status of the printer. This can help you
judge if the printer is normal or not. The setting procedures as below:
1. Enter <System Setup-1>, select <System Status>, it displays as
below:
Status:
Printer is ready
Saturn Technologies Co. Ltd
Target Flow Time
Current Flow Time
Nozzle Drive
Make-up Add Time
Make-up Add Status
2. Select <Exit> or directly press <EXIT> key on the keyboard to
quit "System Status" and go back to <System Setup-2>.
Caution:
1. "Make-up Adding Time" means the actual time that make-up
adding valve opens.
2. "Make-up Adding Status" means if the make-up adding time is 0
of the latest 8 times viscosity measure cycle. "0" means make-up
add time is 0, "1" means make-up add time is not 0.
3. "Jet Time" means the hours after the status "Printer is ink on".
"Running Time" means the hours after switch on the printer.
4. After switch on the printer, the "current flow time" is "target flow
time". It will show the actual flow time of printer after the first of
viscosity measure cycle is done.
Enter <System Maintenance-2> and press <Software Version> to
obtain the software number of the printer.
Each printer has a unique authorized number (machine ID), to use
this function to get the machine ID.
5-36
System Status
2007 / 12 / 13 12:00
4200
Jet Time
4178
Best Phase
30
Running Time
26
11010011
Current Flow Time: 4200
430
2
502
Exit