Saturn S300 Series Service Manual page 49

Installation
Status:
Printer is off
2007 / 12/ 13
12 : 24 : 36
0013
Name
1
Start
0
End
9999
Current Value
13
Ok (F1)
3. There is a select box Illuminated in the "Parameter Setup Zone". Using
<Direction Key> to move the select box to the position needed.
4. The value of "Start" and "End" represents that from which the serial
number starts to what number. When the serial number increases to
"End" value, the printer will print from "Start" value again. For example:
When printing a wire of 100 meters long, the Start value can be set at 1,
and the End value at 100. Then, the printer will print from 1 meter to 100
meters increasingly. When setting Start value at 100, and the End value at
1, the printer will print from 100 meters to 1 meter decreasingly. Then, it
will repeat printing from 100 meter again.
5. "Current Value" means the current serial number when setting it
(Normally set at 1). For example, when printing a wire of 100 meters long,
5 meters should be passed before printing everyday. So, we could set the
Current value at 95, then the printer will print from 95 meters to 100
meters(Pass 5 meters). When the Current value comes to 100, the printer
will print from 1 meter again.
CAUTION: the value of "Current Value" should be within the rang
between Start value and End value.
6. "Leading Zeros" can be opened by right or left key. It displays that
whether the space of the serial number is filled in by zeros. For example,
when inserting a serial number circulate from 1 to 100, there is three bits.
When it displays "No", the leading zeros will be displayed like 1, 2, 3~100;
when it displays "Yes", the leading zeros will be displayed like 001, 002,
003~100.
7. "Step size" indicates how much the serial number increase or decrease
each time (Normally 1). If the Step size is 1, when the value increases 1 for
each time, the screen will displays as 1, 2, 3, 4~100. If the Step size is 2,
when the value increases 1 for each time, the screen will displays as 1, 3,
5, 7~100. If the Step size is 3, when the value increases 1 for each time,
the screen will displays as 1, 4, 7, 10~100.
8. "Repeat Count" shows how many times can each serial number print
repeatedly (Usually show as 1). If each serial number will be print once, it
will display as 1, 2, 3, 4~100. If the value is 2, each serial number will be
printed twice, and it will display as 1、 1、 2、 2～100、 100. For example, when
the customer require change (Increase or decrease) the serial number
after printing 10 product each time, this setup will be applied to, and the
value should be 10.
9. Select <Ok> to finish inserting serial number. And the serial number
information you setup will be displayed in the "Message Edit Zone".
Insert Serial Number
2007 / 12 / 13 12:00
Leading Zeros
Step Size
Repeat Count
Exit (F3)
Cancel (F2)
Current Flow Time: 4200
4-14
Yes
1
1