Saturn S300 Series Service Manual page 83

INK JET PRINTER OPERATION
Print Repeat
Bold Message
It is used for continuous printing application like cable, pipe or lottery
industry etc. The procedures of "print repeat" setup as below:
1. Enter <Print Setup-2>, select <Print Repeat>, it displays as
below:
Status:
Printer is ready
Saturn Technologies Co. Ltd
Repeat Mode
Repeat Pitch
Repeat Count
Ok (F1)
2. Use up/down <Direction Key> and right/left <Adjust Key> to set
up the 3 parameters "Repeat Mode", "Repeat Count" and
"Repeat Pitch" respectively. "Repeat Count" and "Repeat pitch"
can be inserted value directly. "Repeat Mode" can be set in three
ways: Single
("Counted") and Continuous Print ("Continuous"). The "Repeat
Count" is only effective under "Counted Mode". The "Repeat
Pitch" is not effective under Single Time Print.
3. Press <OK> to confirm the setting.
Caution: Repeat printing starts after the first signal of the
product detector and stops until achieving the "Repeat Count" you
setup or there is no signal from product detector any more.
It is used to make the whole message to be boldfaced. The maximum
boldfaced multiple is 9. The procedures to set up as below:
1. Enter <Print Setup-2>, select <Bold Message>;
2. Enter the value directly or use right/left <Adjust Key> to adjust
the value as the multiple you needed. The default value is 1 (no
boldfaced printing).
3. Press <OK> to confirm the settings.
5-31
Print Repeat
2007 / 12 / 13 12:00
Single time
50
1
Cancel (F2)
Current Flow Time: 4200
Time Print ("Off",
Exit (F3)
default), Counted Print